 |
|
 |
 |
| - |
| Dos and Donts |
| Dos |
- Check for oil level daily
- Fill oil ISOVG320 in gear boxes from size VF110 to VF18
- Check the condition of the oil seals
- When fitting the belt driven pulleys, make sure that the shafts are perfectly parallel and that the pulleys are aligned with each other
- Provide overload protection to the electric motors
- Protect motor from water and humidity
|
| Donts |
-
Do not block the breather holes if its is provided. This may lead to the internal pressure and consequent leakage of oil from oil seals and rubber caps.
-
Do not paint on the oil seals Do not hammer the output / input shafts while fitting the pulley or any other drive mechanism. This may lead to breakage of internals
-
Incorrect alignment can cause damage to the motor and the input shaft bearings
-
Avoid over-tensioning the belts since excess tension can cause bearing failure in the gear box
-
Do not run the motor in high voltage fluctuation
-
Do not disturb the original brake settings
-
Do not give brake supply connections separately as it is already connected internally
|
| - |
|
|
 |
 |
